Ideal attachment for ease of starting and priming engine driven pressure washers when sucking the inlet water. To use: Open valve to start and close after starting once water is flowing smoothly out the valve. Fit into the high pressure 3/8F port of the high pressure pump. Ensure all joints are tightly sealed.
V-TUF H4.010 SAND BLASTING KIT a favourite but effective attachment which injects sand in to the high pressure water jet and turns your pressure washer into a sand blaster.
Proven ideal for removing rust and stubborn dirt.
This method is the only way to sandblast without the need for extraction and breathing equipment.
The recommended sand is Kiln Dried Sand (Available from most builder’s merchants or suppliers)
Inlet fitting: M22M
Please note: Specifications can change without prior notice and images are for illustration only. E&OE
The Amazing V-TUF® H5.010 Sludge Pump
Empties a 25 litre drum with a 240 volt pressure
washer in less than 10 seconds !
The V-TUF® H5.010 sludge pump will use 10 litres/minute to
deliver 170 litres/minute without needing further power.
Pumps almost any form of liquid with no blockages and no
mechanical working parts.
The V-TUF® H5.010 sludge pump works on the Venturi principle,
creates a low pressure in the hose, causing it to pump
incredible amounts of muddy water, slurry, etc.
Simply attach your pressure washer hose to the amazing
sludge pump and let it do the work!
! pumping out flooded areas
! cleaning ponds
! high volume water transfers
! drain or pit cleaning
! construction sites for clearing trenches etc.
Some comments from satisfied customers during
” it's amazing, I've never seen anything like it before”,
“why haven't we heard of this idea before
Excellent value for money V-TUF H1.001 SURFACE CLEANER with a commercial specification! 300mm cleaning width; brass and stainless spinner assembly.
Maximum pressure for 210 Bar(3050PSI); Maximum water flow: 15 liters per minute (4 US Gal/min); Maximum temperature: 60oC (140oF)
2 x replaceable stainless steel 15o 02 1/4 BSP fan jets;
high-low pressure adjustment for ideal patio cleaning; driveway cleaning or wood decking cleaning;
Inlet Connection: M22 male x 14mm spigot inlet connector. A 450mm extension is included to add to the 150mm connecting arm.
4 x protected internal wheels for ease of movement;
internal brush skirt to prevent splash;
2 x protected discharge ports – to clear chamber of debris.
2 x handles for close vertical surface cleaning
This V-TUF H1.001 SURFACE CLEANER is suitable for cleaning floors and walls and wood and stone surfaces. " An excellent all-rounder".
Please note: If you need to order a trigger gun too, please order the following codes: T1.080 trigger and T1.357 extension.
500mm (20”) V-TUF H1.007 Heavy Duty Stainless Steel Floor Cleaner with 4x castors; with the NEW improved TWIN JET ‘deep clean’ spindle, for an impressive, splash free and safe cleaning operation. The H1.007 is compatible with any common hot or cold industrial pressure washer – see video link below…
Stainless Steel + water = NO RUST
Stainless Steel Rotary Surface Cleaner (sometimes refered to a Whirl-A-Way or whirlaway ) which is ideally suited for industrial and commercial tasks, such as:
Block Paved Areas
Patios & Driveways
Public walkways and court yards
Concrete Floor Areas
Common wearing parts: VT85790030 Castor Wheel, VT85202017 Trigger
Other order codes: H1.007 ; B021100010-s
Please note: Due to product development, specifications may change without prior notice and images are for specification purposes only. E&OE